---

Tips and tricks

ROLL BAG INSTALLATION:  When installing roll bags into the holder, remove one or two bags from the roll for easier installation.  As bag rolls vary in size, this will prevent your roll from getting stuck during installation.
We recommend 9"x 14" biodegradable bags for most applications.
​
BIG DOGS NEED BIG BAGS:  If you have a big pup, always use large bags for pick-up.  Typical small bags will make it difficult to tie off after pick-up.  Always use size appropriate bags for the task.

Storage

Important:  Do not store your Grab-N-Gone device outside, especially in direct sun as thermal heating can damage internal components over time making it your device inoperable.  Also, avoid storing your device in extreme heat or cold. A good rule of thumb is to store just inside the door or with your dog's leash.  

Operation

Mouse over to see text

REMOVE BAG FROM BAG ROLL HOLDER

LOOSELY SLIDE BAG OVER END OF CANISTER

GENTLY SLIDE HANDLE FORWARD WHILE HOLDING SHAFT

CREATE A POCKET IN THE BAG

IT SHOULD LOOK SOMETHING LIKE THIS

GATHER WASTE INTO POCKET. REMEMBER YOU CAN DO THIS AGAIN IF YOU MISS SOMETHING

BRING THE DEVICE INTO A VERTICAL POSITION

SLIDE HANDLE UPWARD WITH GENTLE PRESSURE AT TOP OF HANDLE

GATHER AND TWIST BAG

MAKE A KNOT

PLACE BAG IN USED BAG HOLDER

.....OR EJECT INTO WASTE CONTAINER